Check the surface where the product would be apply and make sure the surface is:
Place the protective tape where necessary
For the application over completely smooth walls, do only steps 2, 4, 5, 6 and 7.
In the case of application on floors and walls in bad conditions or with tile joints do all the steps.
1. Extend the Fiberglass mesh CimentArt over the surface.
2. Apply a layer of CimentArt Primer with a roller over the fiberglass mesh, exerting some pressure to create adherence on the surface.
3. Microcement base CimentArt
First layer application of Microcement Base:
Allow the Microcement Base to dry completely:
Place the protective tape where necesary.
Apply the second Microcement Base layer:
Remove the protective tape before the Microcement hardens and allow the second layer Microcement Base.
4. Thin microcement CimentArt
Application of the first layer of Thin Microcement:
Place the protective tape where necessary.
Apply a second layer of Thin Microcement following the same result of the first layer.
5. ACTIVITY CimentArt
Moist a sponge with the earlier mixture (Activity CimentArt with water) and with short, semicircular movement rub the surface.
This action can also be done using a spray. The application with sponge or the spray must be done in a controlled fashion avoiding dripping in the walls and puddles on the floor.
To achieve a Natural Oxide effect, the application must be done in an irregular fashion with some areas with more quantity than others, without soaking the surface.
6. Sealer CimentArt
Pour into a painting pan the sealer CimentArt and apply a uniform layer with a shorthaired roller or a microfiber roller.
Clean the Roller and the painting pan with water.
7. Bi-Component Polyurethane water base varnish CimentArt
For the complete finishing of front walls, floors, showers and/or any other surfaces that could be in contact with water, use Bi- component varnish CimentArt.
For any technical guidance write to: email@example.com